A Guide to Lighting up Your Bike with AdMore, Denali, and HEX!
Step 1: Front Lighting
Please note: Denali Light Pods are sold individually. You will need to order 2 x Light Pods for a new installation.
Fitment: Universal
Step 2: Electrical
Denali Light Pods are a plug-n-play installation with a HEX ezCAN or a Denali CANsmart controller. You will need to order a set of extension cables to reach the ezCAN mounted under your seat. If you want to program the light pods to work independently of each other (e.g. turn off a light pod when a turn signal is on) you will need two (2) available outputs. If you are looking to have the light pods function in unison at all times, then you will need to order a splitter cable so that both light pods can run off a single output.
Step 3: Mounts
Denali Light Pods do not come with mounts. You will need to order suitable mounts for your installation.
Step 4: Rear Lighting
Fitment: AdMore Light Bars work on nearly all motorcycles and scooters.
If you have a HEX ezCAN or a Denali CANsmart installed on your bike (or are planning to add one), you will require the AdMore ezLINK to make the installation of any AdMore Light Bar / Light Kit plug ‘n’ play.
Step 5: Horn
Step 6: Horn Installation
Step 7: Accessory Manager
You need an accessory manager to tie in all of your accessories and allow you to install and configure them. If there is no ezCAN available for your specific make and model of bike, you will want to consider the Denali DialDim.